Starlink Flat High Performance Replacement Cable, 10 m (32.8 ft)
$119.99
Replace the cable between your Starlink Flat High Performance dish and its matching power supply with the gray Starlink FHP 10m Cable, made with 22AWG copper wire. Two protective end caps cover the plugs when the cable is disconnected.
| Brand | STARGEAR |
|---|---|
| Part Number | SG-FHP-SPX-SPX-10M |
| Compatible Device | Starlink Flat High Performance dish and matching power supply |
| Cable Length | 10 m (32.8 ft) |
| Wire Gauge | 22AWG |
| Conductor Material | Copper |
| Connector Gender | Male to male |
| Connector Type | Shaped Flat High Performance plugs |
| Color | Gray |
| Included Components | 1 replacement cable and 2 protective end caps |
A 10 m Cable for Your Flat High Performance Dish
The STARGEAR Starlink FHP 10m Cable runs between the dish and matching power supply on a Starlink Flat High Performance kit, also called Performance (Gen 2). Choose this Flat High Performance replacement cable when you need to replace the existing dish cable and 10 m (32.8 ft) covers your planned route.
The gray cable uses 22AWG copper wire and has two differently shaped plugs, one for the dish and one for the matching power supply.
Check Both Plugs Before Ordering
Compare both plug housings with your original cable to make sure the Starlink FHP 10m Cable matches the ports on your dish and power supply. Use this FHP dish cable on the dish side of the power supply, and keep your existing Ethernet connection from the power supply to your router.
Check the dish model in your kit documentation if you are unsure, especially if you have a Standard, Mini, Enterprise or another Performance model.
Measure the Full Cable Route
Measure along the path you plan to use, including bends, wall entries and the distance to each connector, before choosing this 32.8 ft Starlink cable. Leave extra room at both ends so you can plug in the cable without pulling on the ports or forcing a sharp bend behind the equipment.
If your route is too long for the Starlink FHP 10m Cable, choose the separate 25 m (82 ft) version.
Fit the Cable and Keep the Caps
Disconnect power first, then guide each plug into its matching port and check that it seats fully before reconnecting power and checking the connection. Use the protective cable end caps when the plugs are disconnected, such as when you are storing the cable or feeding it through a cable opening.
For an outdoor run, follow the kit’s routing and sealing instructions and keep disconnected plugs dry, even when the protective caps are fitted.
Why You’ll Love It
- A 10 m (32.8 ft) run for equipment that sits closer together.
- 22AWG copper wire inside a gray outer jacket.
- Two shaped plugs for the original FHP dish-to-power-supply connection.
- Two removable caps to cover the disconnected cable ends.



FAQ
Q1: Which Starlink kit does this cable fit?
A1: The Starlink FHP 10m Cable fits the Flat High Performance dish and matching power supply, also known as the Performance (Gen 2) kit.
Q2: Can I use my existing power supply and router?
A2: Yes. Keep the matching FHP power supply and your existing router connection. This cable links the dish to the power supply.
Q3: Should I choose 10 m or 25 m?
A3: Choose 10 m if it covers the full route with slack at both ends. The separate 25 m version suits a longer run.
Q4: What comes with the cable?
A4: The Starlink FHP 10m Cable comes with two removable protective caps, one for each plug. The dish and power supply are separate.
Q5: Can I run the cable outside to a dish on my RV?
A5: Follow your kit’s outdoor routing and sealing instructions. Support the cable along the route and keep disconnected plugs dry.

























Reviews
There are no reviews yet.