82FT Starlink Flat High Performance Replacement Cable, 22AWG

$165.99

Replace the cable between your Starlink Flat High Performance dish and its matching power supply with this gray 25 m (82 ft), 22AWG cable. Two protective end caps cover the plugs when the cable is disconnected.

BrandSTARGEAR
Part NumberFHP-SPX-SPX-25M
Compatible DeviceStarlink Flat High Performance dish and matching power supply
Cable Length25 m (82 ft)
Wire Gauge22AWG
Conductor MaterialCopper
Connector GenderMale to male
Connector TypeShaped Flat High Performance plugs
ColorGray
Included Components1 replacement cable and 2 protective end caps

Starlink FHP Cable 82FT for the Dish and Power Supply

Use the Starlink FHP Cable 82FT if the cable between your Flat High Performance dish and its power supply is damaged, or if you need more reach.

This gray 22AWG replacement cable provides a continuous 25 m (82 ft) run. The two molded plugs have different housings so you can match each end to its port.

Match Your Dish and Power Supply

This Flat High Performance replacement cable runs from the dish to its matching power supply. The cable from the power supply to a router is a separate connection.

Check the kit name and compare both plugs with your existing cable before ordering. A rectangular dish alone is not enough to identify a compatible kit.

Use the Starlink FHP Cable 82FT with the Flat High Performance dish and its matching supply. Choose the cable made for your own kit if you have a Starlink Mini, Standard or a different Performance model.

Measure the Full Cable Route

A 25 m Starlink cable gives you room for a route around walls or through an RV cable passage when a shorter cable will not reach.

Measure along the path the cable will actually follow. Allow for bends, entry points and enough slack to attach both plugs without pulling on either port.

Choose the Starlink FHP Cable 82FT when you need the longer run. If your measured path fits within 10 m with slack, the 32.8 ft version may be easier to route and store.

Connect the Plugs and Use the End Caps

Disconnect the power supply from power before removing the old cable. Keep the old cable nearby so you can compare the plug housings as you work.

Remove the protective end caps before plugging in. Align each connector with its matching port and seat it fully without forcing it.

The plugs have visible sealing rings. Check that the rings and mating ports are clean and undamaged, and follow the equipment maker’s instructions for any exposed installation.

Keep disconnected plugs dry and slip the end caps back on for storage or transport. The caps cover the plug ends when the cable is unplugged.

Support the cable so its weight does not hang from the dish or power supply. Keep it clear of sharp edges, tight bends and places where it may be pinched.

Why You’ll Love It

  • 25 m (82 ft) for a longer dish route.
  • 22AWG replacement cable sized for the Flat High Performance setup.
  • Two shaped plugs for the dish and its matching power supply.
  • Two end caps to cover the plugs when disconnected.
  • One continuous cable from the dish to the power supply.Starlink FHP Cable 82FT detail banner showing both molded plugs and the removable end caps

    Three-panel banner showing the plug and cap, sealing rings and a curved gray cable jacketCable plugs next to their end caps with a circular close-up of the larger cap and illustrated splashesFlat High Performance dish highlighted beside four other Starlink dish stylesSide-by-side examples of cable routing from an RV roof dish and to an indoor wall-mounted power supplyTwo horizontal FHP cable plugs shown with wind, rain, sun and snow graphics

FAQ

Q1: Which Starlink kit does this fit?

A1: The Starlink FHP Cable 82FT is for the Flat High Performance dish and its matching power supply. Check both existing plugs before ordering.

Q2: Should I choose 82 ft or 32.8 ft?

A2: Choose 82 ft if the route needs more than 32.8 ft once you allow for bends and slack. Measure along the actual cable path first.

Q3: Do I need a new power supply or an adapter?

A3: Use your existing compatible Flat High Performance power supply. The cable plugs into the matching dish and power supply ports without a separate adapter.

Q4: Can I route the cable outside or on an RV?

A4: Follow your kit’s outdoor routing instructions and seat both plugs fully. Keep unplugged ends dry, and keep connections away from standing water.

Q5: What comes with the Starlink FHP Cable 82FT?

A5: One gray 25 m (82 ft) cable and two protective plug caps are included. The dish and power supply are separate.

Reviews

There are no reviews yet.

Be the first to review “82FT Starlink Flat High Performance Replacement Cable, 22AWG”

Your email address will not be published. Required fields are marked *

Secure Payments
Secure Payments. Encrypted & Protected.
Worldwide Shipping
Shipping to 200+ Countries & Regions.
Gifts & Sales
Curated Gifts for Every Occasion.
24/7 Support
Live Support via Chat, Email, or Phone.

Starlink FHP Cable 82FT coiled in gray with two molded plugs, two end caps and a STARGEAR box
82FT Starlink Flat High Performance Replacement Cable, 22AWG

$165.99

Add to cart